It easier to make it shorter )Ī piece of teflon wire is used to pull the new new wire through the arm tube. Always allow for much more than you think you'll need. The headshell is then removed, and four lengths of Litz wire prepared. Undo this, and don't lose the washer underneath it. Bingo, the small silver cover pops out, and reveals a small black plastic nut. Get a piece of blu-tak, and stick it over the pivot. I spent a few minutes looking at this, trying to work out how to get the headshell pivot apart. I didn't do this at this time, and broke the wiring, not that that mattered. There's a small grub screw at an angle, losen this to remove the plastic insulation "top hat" which the wiring passes through. Removal of two screws allow the separation of the arm tube from the bearing support. Slacken the arm bearing off, this will allow extraction of the arm. Undo the gimbal housing screw and slide the gimbal housing down the arm and put that somewhere safe.Īs there was no doubt in my mind that the wiring was at fault, I just cut it off. Ĭartridge Slide out first, and put it to one side, so we don't damage it. Now I'm one of those odd people who actually enjoy arm wiring, but this could be a little daunting.Ī quick google search chucks up loads of people who say it can be done, but it's very difficult neigh on impossible etc etc etc. Funny, didn't think I had the mono press of this.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |